When we bought the Red Goldwing I didn’t like how low the factory installed screen was so after visiting the Clearview Shields shop I purchased a Clearview Shield that was about 4 inches higher and quite a bit wider than the stock one. Here’s what I had to do to change it out on the 2007 Wing:
The original Screen is low and not as wide as the Clearview so I take the time to switch them out.
The top horizontal bolt is the one I’m after.
First thing is to bend the mirrors back and stuff a rag in the opening so if the bolt gets away from you it won’t end up in never ever land in the body.
Here’s the bolt and the special washer that snugs up against the screen.
Next I remove the nose piece simply by prying up at the front and then pulling slightly on the sides where the nuts are removed.
Next I have to loosen the bolt holding the black plastic piece so I can get at the windscreen bolt underneath
Here is the bolt, the top one.
These side screws hold the screen in place on the sliding mechanism.
Here’s the middle plate that has two screws that hold the screen on the sliding mechanism.
We remove all screws and lift off the OEM shield and replace with the Clearview. Reinstall everything in the reverse order.
EV & TJ's 3rd Wheel Travels 